![]() ![]() c listno Set communication port from the following list (default 1)ġ = '/dev/bus/usb/001/005 (GretagMacbeth i1 Display 2)' It reports with usb vendor id 0971 and product id 2003 (same as the iDisplay 2 mentioned above). I am on Fedora 20 and the label on my device says it's a X-Rite eye-one display Lt (Rev C). As a result colord cannot correctly determine the communication port it should pass to spotread and calibration fails. It looks like spotread and colord use different names for the colorimeter. ![]() I did some digging and I think I have found the cause of the internal error. Hit Esc or Q to give up, any other key to retry: Hit ESC or Q to exit, any other key to take a reading: q Hit ESC or Q to exit, any other key to take a reading: 'h' to toggle high res., 'k' to do a calibration refresh rate, 'F' to measure refresh rate 'r' to set reference, 's' to save spectrum, to read and make FWA compensated reading from keyed reference I1disp: instrument is responding, unlocked, and right typeĪnd hit to read white and setup FWA compensation (keyed to letter) Usb_open_port: open port '/dev/bus/usb/001/011' succeeded New_inst: called with path '/dev/bus/usb/001/011 (GretagMacbeth i1 Display 2)' Usb_check_and_add: found instrument vid 0x0971, pid 0x2003 Spotread seems to work correctly when called directly: This same hardware worked flawlessly in Fedora 18 on my laptop. Sensor: Gretag-Macbeth AG - Eye-One display Running "colormgr get-sensor-reading lcd" results in: Running "/usr/libexec/colord-session -v" while attempting to run the profile results in:Ģ2:26:17 Verbose debugging enabled (on console 1)Ģ2:26:17ĜdMain: acquired name: Ģ2:26:38ĜdMain: :1.163:Start(xrandr-Dell Inc.-DELL SE198WF-737318A71N3U,i1-pro-00)Ģ2:26:38ĜdMain: Emitting InteractionRequired(0,attach the sensor to the screen,/usr/share/colord/icons/i1-pro-attach.svg)Ģ2:26:42ĜdMain: Emitting UpdateGamma(2 elements)Ģ2:26:42ĜdMain: Emitting UpdateSample(1.000000,1.000000,1.000000)Ģ2:26:43ĜdMain: Emitting Finished(1,spotread exited unexpectedly) Try to calibrate the monitor (either monitor on a 2-display setup).Īn internal error occurred that could not be recovered. Version-Release number of selected component (if applicable): Can't calibrate the display with an X-Rite "eye-one display 2" ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |